Table of Contents
Advertisement
Upgrading Your System
Installing SIMMs
1.
Open the first memory upgrade kit and take out the SIMM.
2.
Position the SIMM at a 45° angle to the motherboard, as shown in
Figure 1–5.
Note:
SIMMs are keyed and will not seat fully if they are not correctly oriented.
3.
Push the SIMM down into the socket, then rock it toward the motherboard. You
will hear a soft click as the retaining clips latch the SIMM into place.
4.
Repeat steps 1 through 3 for the installation of the other SIMM.
5.
Replace the front panel, as described earlier in this section.
6.
Replace the system unit cover, as described earlier in this section, then turn the
system on.
7.
When the System Configuration Screen appears (see Figure 1–4), press Pause.
8.
Verify that the System Memory and Extended Memory values displayed add up to
the total installed memory.
9.
If the System and Extended Memory do not add up to the total memory you just
installed, refer to Section 3, "Troubleshooting an Installation Problem."
1–14
3814 9779-000
Advertisement
Table of Contents
Troubleshooting
