2.3.27 Remote Call Forwarding Set (DPT Integration Only)
Subscriber's Manual References
3.1 Playing Messages
3.2 Replying to Messages
2.3.26 Recover Message
Description
Enables a subscriber to recover deleted messages. After deleting messages, they will remain in the Deleted
Message Box until the end of the day. Until then, the subscriber can retrieve the deleted messages from the
Deleted Message Box and move them to the Old Message Box. Message retention time is reset when a
message is recovered.
Subscriber's Manual References
5.21 Recovering Deleted Messages
2.3.27 Remote Call Forwarding Set (DPT Integration Only)
Description
Allows subscribers and the Message Manager to program their extensions from a remote location in order to
forward calls to another extension or to an outside telephone.
There are 6 forwarding settings available:
FWD All: Forwards all incoming calls to the desired extension number.
FWD Busy: Forwards all incoming calls to the desired extension number when the line is busy.
FWD No Answer: Forwards all incoming calls to the desired extension number when there is no answer.
FWD Busy or No Answer: Forwards all incoming calls to the desired extension number when the line is busy
or there is no answer.
FWD to CO: Forwards all incoming calls to the Telephone number 1 or 2 (programmed in the Mailbox Setting),
or to any other number. This feature is only available when the Class of Service's "Remote Call Forward to
CO" parameter is set to "Yes" (see "Remote Call Forward to CO" in 2.2.2 Personal Options in the Programming
Manual).
FWD Cancel: Cancels the forwarding setting.
Conditions
•
With respect to PBX programming, it is possible that "Call Forward to CO" is disabled. To enable VPS
Remote Call Forwarding, the KX-TDA100, for example, must be programmed properly. For the COS of the
extensions whose calls are to be forwarded to a trunk, enable the following: [504] Call Forward to Outside
Line.
•
Extensions assigned as operators can be called by dialing [0], however, when setting this feature the
extension number (not "0") must be specified.
Programming Manual References
2.1.9 Remote Call FWD To CO
"Remote Call Forward to CO" in 2.2.2 Personal Options
46
Feature Manual
Document Version 3.0 2010/06