National Instruments NI cRIO-9035 User Manual page 8

The following NI Ethernet cables are available for the cRIO-9035.
CAT-5E Ethernet Cable, shielded
Related Information
Ethernet LED Indicators
Power Connector
The cRIO-9035 has a power connector to which you can connect a primary and secondary
power supply. The following table shows the pinout for the power connector.
Pinout
V1
C
V2
C
Caution
connected to chassis ground. This isolation is intended to prevent ground loops and
does not meet UL ratings for safety isolation. You can connect the C terminals to
chassis ground externally. Refer to the specifications on
information about the power supply input range and maximum voltage from
terminal to chassis ground.
If you apply power to both the V1 and V2 inputs, the cRIO-9035 operates from the V1 input.
If the input voltage to V1 is insufficient, the cRIO-9035 operates from the V2 input.
The cRIO-9035 has reverse-voltage protection.
The following NI power supplies and accessories are available for the cRIO-9035.
NI PS-15 Power Supply, 24 VDC, 5 A, 100-120/200-240 VAC Input
NI PS-10 Desktop Power Supply, 24 VDC, 5 A, 100-120/200-240 VAC Input 782698-01
8 | ni.com | NI cRIO-9035 User Manual
Table 3. RJ-45 Gigabit Ethernet Cables
Cables
on page 19
Table 4. Power Connector Pinout
Pin
V1
C
V2
C
The C terminals are internally connected to each other, but are not
Table 5. Power Accessories
Accessory
Length
Primary power input
Common
Secondary power input
Common
Part Number
2 m 151733-02
5 m 151733-05
10 m 151733-10
Description
ni.com/manuals for
Part Number
781093-01