Module Immobilization Accessory Dimensions - National Instruments NI cRIO-9035 User Manual

2
1. Ensure that all the C Series modules are installed in the cRIO-9035 and the latches are
locked in place.
2. Remove the center right panel screw from the top and bottom of the cRIO-9035 using the
Torx T10 driver.
3. Slide the bracket into place, aligning the three clearance screw holes.
4. Install the M4 x 0.7 button-head screw in the right end of the cRIO-9035 using the
appropriate Torx T20 driver. Tighten the screw to a maximum torque of 1.3 N · m
(11.5 lb · in.).
5. Install the two M3 x 0.5 flat-head screws from the accessory kit in the top and bottom of
the cRIO-9035 using the appropriate Torx T10 driver. Tighten the screws to a maximum
torque of 1.3 N · m (11.5 lb · in.).
Tip
is expected to experience vibration for an extended amount or time.

Module Immobilization Accessory Dimensions

The following figure shows the Module Immobilization accessory dimensions for the
cRIO-9035.
5
1
NI recommends using a liquid thread locker for all fasteners if the system
NI cRIO-9035 User Manual | © National Instruments | 23
3
4