National Instruments NI cRIO-9035 User Manual page 7

1. RJ-45 Gigabit Ethernet Ports
2. Power Connector
3. SD Card Removable Storage
4. RS-232 Serial Port
RJ-45 Gigabit Ethernet Ports
The cRIO-9035 has two tri-speed RJ-45 Gigabit Ethernet ports. By default, both Ethernet ports
are enabled and configured to obtain an IP address automatically. The Ethernet ports can be
configured in MAX.
The following table shows the pinout for the RJ-45 Gigabit Ethernet ports.
Fast Ethernet Signal
No Connect
No Connect
No Connect
No Connect
Note Both Ethernet ports perform automatic crossover configuration so you do not
need to use a crossover cable to connect to a host computer.
Figure 1. cRIO-9035 Ports and Connectors
8
7
Table 2. RJ-45 Gigabit Ethernet Port Pinout
Gigabit Ethernet Signal
TX+
TX-
RX+
RX-
1 2
6 5 4
5. RS-485/422 (DTE) Serial Port
6. Mini DisplayPort
7. USB Host Ports
8. USB Device Port
Pin
TX_A+ 1
TX_A- 2
RX_B+ 3
TX_C+ 4
TX_C- 5
RX_B- 6
RX_D+ 7
RX_D- 8
NI cRIO-9035 User Manual | © National Instruments | 7
3
Pinout
1
2
3
4
5
6
7
8