Leds - National Instruments NI cRIO-9035 User Manual

Press and hold
RESET button for < 5 s
Press and hold RESET button for ≥ 5 s
Run Mode
Press and hold RESET button for < 5 s
Press and hold RESET button for < 5 s
USER1 Button
The cRIO-9035 has a general-purpose USER1 button that is user-defined. You can read the
state of the USER1 button from your LabVIEW FPGA application.
CMOS Reset Button
The cRIO-9035 has a CMOS reset button that you can use to reset the CMOS and the BIOS.

LEDs

The cRIO-9035 provides the following LEDs.
1. POWER LED
2. STATUS LED
3. USER1 LED
16 | ni.com | NI cRIO-9035 User Manual
Figure 4. Reset Button Behavior
Figure 5. cRIO-9035 LEDs
1 2 3 4
4. USER FPGA1 LED
5. Gigabit Ethernet LEDs
6. SD LEDs
• Console Out enabled
Safe Mode
• RT Startup App disabled
• FPGA Startup App disabled
Press and hold RESET button for ≥ 5 s
• Console Out enabled
• Network settings reset
Safe Mode
• RT Startup App disabled
• FPGA Startup App disabled
Press and hold
RESET button for ≥ 5 s
5
6