Table of Contents
Advertisement
Installation and connection
Electrical connection
The appliance must be connected to the mains by a licensed
expert. The regulations of your electricity supplier must be
observed.
Any damage arising from the appliance being connected
incorrectly will invalidate the guarantee.
For the installer
An all-pole isolating switch with a contact gap of at least
■
3 mm must be present in the installation circuit. This is not
necessary if the appliance is connected by a plug that is
accessible to the user.
Electrical safety: The cooker corresponds to safety class I
■
and may only be used in conjunction with a safety earth
terminal.
Your new cooker
Here you will learn about your new cooker. We will explain the
control panel, the hob and the individual operating controls.
You will find information on the cooking compartment and the
accessories.
Explanations
1
Ceramic hob
2
Hotplate controls
3
Rotary selector
4
Control buttons with display panel
5
Cooling fan
6
Oven door
7
Plinth drawer
Control knobs
The control knobs can be pushed in and remain pressed down
when they are in the "out" position. Press down on the control
knob again to release it back up.
A type H 05 VV-F or equally rated lead must be used to
■
connect the appliance.
Levelling the cooker
Always place the cooker directly on the floor.
The cooker has height-adjustable feet. This allows you to raise
the plinth by about 15 mm. Please observe the special
installation instructions.
Wall fixing
To prevent the cooker from tipping over, you must fix it to the
wall at the chain and with the protection angle. Please observe
the installation instructions for fixing the oven to the wall.
Overview
Depending on the appliance model, individual details may
differ.
7
Advertisement
Table of Contents
