Table of Contents
Advertisement
Starting up
Start up the appliance in accordance with the in-
1.
struction manual.
Ignite all of the burners.
2.
Check the stability of the flames at a high and
‒
low setting.
Moving or transporting the appliance by the gas
pipe (collector) or by the door handle
Do not move the appliance by pulling on the gas
1.
pipe (collector).
a The gas pipe may be damaged and a gas leak may
occur.
Do not move the appliance by holding it by the door
2.
handle.
a This may damage the door hinges and door handle.
4.3 Electrical connection
Only allow a licensed professional to connect the appli-
ance. You must comply with the requirements of your
electricity supplier.
¡ The appliance is designed for operation at 220-240
V. 16 A fuse
¡ Any damage arising from the appliance being con-
nected incorrectly will invalidate the warranty.
CAUTION ‒ !
The power cable may be damaged. The damage to the
power cable may lead to a dangerous situation.
The power cable must be replaced by the manufac-
▶
turer, their after-sales service or a similarly qualified
person.
¡ The appliance must always be disconnected from
the power supply when installation work is being
carried out.
¡ The appliance fulfils the requirements of protection
class I and must only be connected to an earthed
mains socket.
¡ The mains power cable must be at least type H05 V
V-F 3G 1 mm².
4.4 Appliance categories
Country
RU, BY, KZ, AM, KG
UA
MA
AE, LB, JO
EG
Information
1
2
3
Important information about the electrical
connection
Note the following information and ensure that:
There is a risk of electric shock if you touch live com-
ponents.
▶
▶
▶
¡ Fit the mains plug and socket together.
¡ The mains plug can be accessed at all times.
¡ The cross section of the cable is sufficient.
¡ The mains cable is not kinked, crushed, modified or
¡ If required, the mains cable must only be replaced
¡ Do not use any multiple plugs or multi-connectors
¡ The earthing system is correctly installed.
¡ If using a residual current device, only use one that
¡ The mains cable does not come into contact with
Category
II 2H3B/P
II 2H3B/P
I 3+
II 2H3B/P
II 2H3+
Installation and connection en
WARNING ‒ Risk of electric shock!
Hold the mains plug with dry hands only.
Never pull out the mains plug from the socket while
the appliance is in operation.
Pull out the power cable directly at the plug and
never by pulling the power cable as this may be-
come damaged.
severed.
by a qualified electrician. A replacement mains
cable is available from the after-sales service.
and extension cords.
bears the mark
. The presence of this mark is the
only way to be sure that it fulfils all the applicable
regulations.
heat sources.
P (mbar)
2000 тта–3000 тта
20 - 28 - 30
28 - 30/37
20 - 28 - 30
20 - 28 - 30/37
Yellow + green
Brown
Blue
9
Advertisement
Table of Contents
