Table of Contents
Advertisement
Do NOT unscrew the left and right-hand screws from the
7.
sheet metal part (fig. E).
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
Insert the lower panel at an angle towards the back (fig. A).
1.
Slide in the middle panel (fig. B).
2.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Problem
The appliance does not work.
‹‹
:
‹‹
appears in the display.
The oven door cannot be opened.
is shown in the display. The
displayed.
The oven does not heat up or the type of
heating selected cannot be set.
The oven does not heat up. A small
square lights up in the temperature dis-
play.
"
" appears on the display.
"‰
22
Possible cause
Circuit breaker faulty.
Power cut
Power cut during self-cleaning.
:
‹‹
‹‹
L
symbol is
Type of heating not recognised
The oven is in demo mode.
Automatic switch-off has been
activated. The oven stops heating.
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the retaining carriers are over
the screw holes, and then screw into place (fig. C).
Hook the seal in to the bottom of the panel again (fig. D).
4.
Insert the uppermost panel at an angle to the back into the
5.
brackets. Take care not to push the seal to the back (fig. E).
Insert the two small seals on the left and right of the panel
6.
again (fig. F).
Put the cover back in place and screw it on.
7.
Attach the oven door.
8.
Do not use the oven again until the panels have been
correctly installed.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Reset the clock.
Reset the clock. Wait until the
in the display. You can open the oven door again.
Make the settings again.
Switch off the circuit breaker in the fuse box, then
switch it back on after at least 20 seconds. Within
the next 2 minutes, press and hold the
for 4 seconds until the square disappears from the
display.
Press any button.
symbol goes out
L
D
button
Advertisement
Table of Contents
