Reverse The Door Swing - Matsui MUF987W Instruction Book

6

Reverse the door swing

NOTES
• Ensure the Freezer is unplugged and empty.
• Adjust the two levelling feet to their highest
position.
• We recommend you have someone to assist
you.
Tools required
• Phillips style screwdriver
• Flat bladed screwdriver
3.
Slide the door down and off the top hinge pin and
lift away from the appliance.
7.
Slide the Freezer door back on to the top hinge,
making sure it's the right way up.
Screw the bottom hinge into place on the new
side.
Note: to take the door off it is necessary to tilt the
Freezer backward. You should rest the Freezer on
something solid and place something under the
rollers so that it will not slip during the door
change process.
DO NOT lay the Freezer completely flat as this
may damage the coolant system.
4.
Remove the blanking plates covering the handle
screws using a flat bladed screw driver. remove
the screws and then remove the handle.
Check that door is
aligned horizontally and
vertically and that the
seals are closed on all
sides before finally
tightening the bottom
hinge.
Re-adjust the levelling
feet.
1.
Undo the screws and remove the hinge bracket
from the base. A spanner may be required to
loosen the bolts first.
Remove the blanking plates from the opposite
side of the door and screw the handle into
place. Replace all the blanking plates.
8.
2.
Remove the screws and bracket from the opposite
side and fit back to where the hinge bracket was
located.
6.
Remove screws and hinge bracket and refit on opposite
side.