Reverse The Door Swing - Matsui MTF1857W Instruction Book

6

Reverse the door swing

NOTES
• Ensure the Appliance is unplugged and empty.
• Adjust the two levelling feet to their highest
position.
• We recommend you have someone to assist
you.
Tools required
• Phillips style screwdriver
• Flat bladed screwdriver
Slide the door down and off the top hinge pin Slide the door down and off the top hinge pin and
and lift away from the appliance.
lift away from the appliance.
Check that door is
aligned horizontally
and vertically and that
the seals are closed on all
sides before finally
tightening the bottom
hingle.
Re-adjust the levelling
feet.
Note: to take the door off it is necessary to tilt the
Appliance backward. You should rest the Freezer on
something solid and place something under the
rollers so that it will not slip during the door
change process.
DO NOT lay the Appliance completely flat as this
may damage the coolant system.
Remove the hinge bush at the top of the door
and swap it with the blanking plate on the other
side. Repeat with the hinge bush and blanking
the screws and then remove the handle.
plate on the bottom of the door.
1.
Undo the screws and remove the hinge bracket
from the base. A spanner may be required to
loosen the bolts first.
Using a screw driver, remove the pin from the
top bracket. Replace it on the opposite bracket.
Ensure the pin is secure
2.
Remove the screws and adjustable foot from the
opposite side and fit back to where the hinge
bracket was located.
Slide the door on to the top hinge, ensuring it
is all the way up. Screw the bottom hinge into
place on the new side and replace the adjustable
feet