Table of Contents
Advertisement
LAN1/LAN2 Enable/Disable
Jumpers JPL1 and JPL2 enables or disables LAN ports 1 and 2 on the motherboard. See
the table below for jumper settings. The default setting is enabled.
4.5 LED Indicators
LAN LEDs
The LAN ports are located on the I/O back panel on the motherboard. Each Ethernet LAN
port has two LEDs. The yellow LED indicates activity. Link LED, located on the left side of
the LAN port, may be green, amber or off indicating the speed of the connection.
LAN 1/2
Link LED
IPMI LAN LEDs
In addition to LAN1 and LAN2, an IPMI LAN is also located on the I/O back panel. The
amber LED on the right indicates activity, while the LED on the left indicates the speed of
the connection.
LAN 1/LAN 2
IPMI LAN
Link LED
IPMI LAN
(X8ST3-F)
M.2 LED
An M.2 indicator (LE3) blinks green when M.2 is functioning normally.
LAN Enable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled (default)
Piins 2-3
Disabled
Activity LED
Activity LED
Chapter 4: Motherboard Connections
LAN1 Link Indicator
LED Settings
LED Color
Definition
Off
No Connection, 10 or 100 Mbps
Green
10 Gbps
Amber
1 Gbps
LAN1 Link Indicator
LED Settings
LED Color
Definition
Green
100 Mbps
Amber
1 Gbps
63
Advertisement
Table of Contents
