Storage Drives At The Chassis Rear - Supermicro SuperStorage 5049P-E1CR45L User Manual

Storage Drives at the Chassis Rear

There is room for two sets of two hot-swap 2.5" drives in the rear of the chassis. The pair at
the top of the chassis supports SATA; the optional pair at the bottom supports NVMe.
SATA Rear Bays
NVMe Rear Bays
Installing 2.5" Drives at the Chassis Rear
1. Press the release button and the carrier lever pops out. Pull out the carrier by the lever.
2. Remove the dummy drive and insert drive into the carrier.
3. Push the carrier assembly into the bay until it clicks into place.
Carrier Lever
Release Button
Figure 3-9. Removing the Carrier and Dummy Drive
Chapter 3: Maintenance and Component Installation
Figure 3-8. Drives at Chassis Rear
47
Dummy Drive
Hard Drive Carrier