Table of Contents
Advertisement
en
Operation
On the control panel, buttons B and G
and all LEDs briefly light up once and a five-
level audible signal sounds. Button B then
flashes. The appliance is in standby mode
and is ready for operation.
Operation
Function selection mode
In function selection mode, all preparation
programmes are selected and all settings
are made on the appliance. To do this,
perform the following steps:
W Risk of scalding!
During operation, the appliance must never
be used without the pan and the steam
outlet inserted.
Caution!
Each time prior to operation, check the
appliance for damage, completeness,
cleanliness and proper installation.
X "Before using for the first time" see
page 26
1. The appliance is ready to use. Press
button B in order to access function
selection mode.
In function selection mode, button B and
the indicator [
permanently lit. Button G flashes. "00:00"
is shown in the display.
Note: If no input is made on the control
panel within 5 minutes, the appliance
automatically switches to standby mode.
Selecting and starting a
preparation programme
There are 16 pre-configured preparation
programmes available to choose from.
X "List of preparation programmes" see
page 36
1. Fill the appliance with the desired
ingredients. To do this, open the lid and
pour the ingredients into the pan. The
measuring scale on the inside of the pan
can also be used to read the quantity.
28
] (my recipe) are
Caution!
■ Do not fill the pan beyond the marking
[4.0 litres]!
■ Use only the spatula provided for stirring
(do not use metal cutlery).
2. Close the lid and press button B to
access function selection mode.
Note: Certain preparation programmes
or steps are carried out with the lid open.
X See recipe book provided
3. Keep pressing button D until the
desired preparation programme is
selected.
The corresponding LED lights up in the
control panel and the pre-configured
preparation time for the selected
preparation programme flashes.
4. Press button G to start the preparation
programme.
The appliance heats up the pan until the
target temperature is reached. During
the heating phase, lines that light up in a
clockwise direction appear in the display.
Once the target temperature is reached,
the lines go out and the preparation time is
shown in the display.
The preparation process starts
automatically.
Note: When the programme [
or [
] (soft fry) is selected, a repeating
audible signal is emitted and the display
and button G flash until the food has been
added and button G has been pressed.
The preparation time counts down.
Steam that is formed when preparing the
meals exits the multi-cooker via the steam
outlet, thereby preventing the formation of
excess pressure.
Increasing or reducing the
temperature during preparation
If the current temperature was set too high
or too low during the preparation, this can
be increased (by +10°C max.) or decreased
(by -10°C max.) accordingly during the
cooking process.
] (pasta)
Advertisement
Table of Contents
