Table of Contents
Advertisement
To increase the temperature, press and
hold button C. The current temperature will
be briefly shown on the display and will
then increase in 1°C increments until the
maximum value is reached (+10°C). Press
and hold the button until the temperature is
at the increased level desired.
To reduce the temperature, press and
hold button C. The current temperature will
be briefly shown on the display and will
initially increase in 1°C increments until the
maximum value is reached (+10°C). Once
the maximum value has been reached, the
display will jump back to the minimum value
(20°C lower). Press and hold the button
until the temperature is at the reduced level
desired.
To continue with the preparation
programme, press button G.
Note: If button G is not pressed, the
preparation programme will continue with
the temperature that was previously set.
When the preparation programme ends,
an audible signal sounds and the indicator
[
] (finished) and button G light up. The
display flashes and shows "00:00".
5. Open the lid of the appliance and serve
the meal that has been prepared.
W Risk of scalding!
■ During preparation, large amounts of
steam may accumulate in the appliance.
Open the lid with care. Do not lean over
the lid of the appliance.
■ The pan and any inserts that are used
may be very hot. Always use pan tongs,
suitable handles or oven gloves.
Notes:
■ The preparation programme can be
stopped at any time using button H.
The appliance subsequently switches to
function selection mode.
■ If the preparation programme features
the keep warm function, this is switched
on automatically once the meal is ready
and keeps the meal warm for up to
10 hours at 40°C. [
[
] (keep warm) light up. A rectangle
lights up in the display (dotted lines).
] (finished) and
The keep warm function can be
ended using button H. The appliance
subsequently switches to function
selection mode.
If the selected preparation programme
consists of multiple preparation steps, an
audible signal sounds once the next step
needs to take place. In the control panel,
LEDs 1, 2, 3 or 4 are shown accordingly
and button G flashes. Perform the
following steps:
■ Open the lid of the appliance.
■ Add additional ingredients.
■ Close the lid of the appliance.
■ Start the next preparation step using
button G.
The appliance heats up the appliance
interior until the target temperature of the
next preparation step is reached. During
the heating phase, lines that light up in a
clockwise direction appear in the display.
Once the target temperature is reached, the
lines go out and the next preparation time
is shown in the display. The preparation
process starts automatically. The
preparation time counts down.
Selecting a pre-configured
preparation time
The pre-configured preparation time of
the level [
] (medium) is shown on
the control panel for each preparation
programme.
The preparation time can be shortened
[
] (short) or lengthened [
1. Keep pressing button E until the
desired indicator is lit. The display
changes from [
[
] (long) and then to [
before returning to [
The corresponding pre-configured values
for the preparation time are shown in the
display.
2. Press button G to start the preparation
programme.
Operation
] (long).
] (medium)to
] (short)
] (medium).
en
29
Advertisement
Table of Contents
