Table of Contents
Advertisement
X20(c)CP1301, X20CP1381 and X20CP1382
6.4 RS232 interface (IF1)
The non-electrically isolated RS232 interface is primarily intended to serve as an online interface for communication
with the programming device. It is located on the X1 I/O slot.
6.5 Ethernet interface (IF2)
The IF2 interface is designed for 10BASE-T / 100BASE-TX transmission.
The INA2000 station number can be set using the Automation Studio software.
Information about cabling X20 modules with an Ethernet interface can be found in the module's download section
at (www.br-automation.com).
Information:
The Ethernet interface (IF2) is not suitable for POWERLINK (see
15).
Pinout
Interface
Shielded RJ45
14
E
R
RF
S
E
ET
PL
A1
A2
1
2
3
4
C
S
T
DC
Figure 2: RS232 interface (IF1) on the X1 I/O slot - Pinout
Pin
1
RS232 TXD
RS232 RXD
GND
"POWERLINK interface (IF3)" on page
Ethernet
1
TXD
2
TXD\
3
RXD
4
Termination
5
Termination
6
RXD\
7
Termination
8
Termination
Pinout
Transmit data
Transmit data\
Receive data
Receive data\
Data sheet V1.21
Advertisement
Table of Contents
