Step 2: Install Mounting Plate; Step 3: Drill Wall Hole - Beko BBVHO 090 User Manual

9 Indoor unit installation
9.2 Step 2: Install mounting
plate
2.1 Take the mounting plate from the back of
indoor unit.
2.2 Ensure to meet the minimum installation
dimension requirements as step 1, according
to the size of mounting plate, determine the
position and stick the mounting plate close
to the wall.
Note:
1. Make sure the mounting
plate is firm enough and
C
flat against the wall after
installation.
2. This figure shown may be
different from the actual
object, please take the latter
as the standard.
9.3

Step 3: Drill wall hole

A hole in the wall should be drilled for refrigerant
piping the drainage pipe, and connecting cables.
3.1 Determine the location of wall hole base on
the position of mounting plate.
40 / 120 EN
2.3 Adjust the mounting plate to a horizontal
2.4 Put down the mounting plate and drill holes
2.5 Insert expansion rubber plugs into the holes,
Spirit level
Mounting plate
3.2 The hole should be have a 70mm diameter
3.3 Drill the wall hole with 70mm core drill and
3.4 Place the wall sleeve and wall sleeve cover
A
Wall sleeve Cover
(Optional)
Indoor
state with a spirit level, then mark out the
screw hole positions on the wall.
in the marked positions with drill.
then hang the mounting plate and fix it with
screws.
Reference screw positions
at least and a small oblique angle to
facilitate drainage.
with small oblique angle lower than the
indoor end about 5mm to 10mm.
(both are optional parts) to protect the
connection parts.
Warning:
When drill the wall hole, maker
sure to avoid wires, plumbing and
other sensitive components.
Wall sleeve
(Optional)
5-10mm
Small bolique angle
Split type air conditioner / User Manual
Outdoor