Mounting Plate Dimensions - Beko BEVPI 090 User Manual

4 Installation
If the wall is made of brick,
concrete, or similar material, drill
C
5mm-diameter (0.2in-diameter)
holes in the wall and insert the
sleeve anchors provided. Then
secure the mounting plate to the
wall by tightening the screws
directly into the clip anchors.
Step 3: Drill wall hole for connective piping
1. Determine the location of the wall hole based
on the position of the mounting plate. Refer to

Mounting Plate Dimensions.

2. Using a 65mm (2.5in) or 90mm (3.54in)
(depending on models) core drill, drill a hole in
the wall. Make sure that the hole is drilled at a
slight downward angle, so that the outdoor end
of the hole is lower than the indoor end by about
5mm to 7mm (0.2-0.275in). This will ensure
proper water drainage.
3. Place the protective wall cuff in the hole. This
protects the edges of the hole and will help seal
it when you finish the installation process.
CAUTION! When drilling the wall
A
hole, make sure to avoid wires,
plumbing, and other sensitive
components.
Wall
Wall
Indoor
Indoor
Split Type Air Conditioner / User Manual
Outdoor
Outdoor
4.2.2 Mounting plate dimensions
Different models have different mounting plates.
For the different customization requirements,
the shape of the mounting plate may be slightly
different. But the installation dimensions are the
same for the same size of indoor unit. See Type A
and Type B for example:
Correct orientation of Mounting Plate
Correct orientation of Mounting Plate
Type A
Type A
101mm (4in) 101mm (4in)
Left rear wall hole
Left rear wall
65mm (2.5in)
hole 65mm (2.5in)
722mm (28.45in)
722mm (28.45in)
Model A
Model A
228mm (8.98in)
228mm (8.98in)
Left rear wall hole
Left rear wall
65mm (2.5in)
hole 65mm (2.5in)
802mm (31.6in) 802mm (31.6in)
Model B
Model B
Type B
Type B
348.4mm (13.7in)
348.4mm (13.7in)
179mm (7.05in) 179mm (7.05in)
136mm (5.35in) 136mm (5.35in)
Indoor unit outline Indoor unit outline
Right rear wall
Right rear wall
hole 65mm (2.5in)
hole 65mm (2.5in)
401mm (15.78in)
401mm (15.78in)
229mm (9.01in)
229mm (9.01in)
126mm (4.96in) 126mm (4.96in)
Indoor unit outline Indoor unit outline
Right rear wall hole
Right rear wall
65mm (2.5in)
hole 65mm (2.5in)
23 / 184 EN