Set The Reading For The Flow Rate; The Flow Rate - Auto-Vol And Auto Mas Mode - Badger Meter Blancett B3100 Service Bulletin

Blancett B3100 Flow Monitor

2.3 Set the reading for the flow rate

This chapter explains the procedure how to setup the measurement unit for reading the
B3100.

2.3.1 The flow rate - AUTO-VOL and AUTO MAS mode

This setting does not influence the K-Factor measurement unit as set from the flowmeter
certificate. The displayed measurement unit, as you selected, for the flow rate is calculated
from the settings in the flowmeter menu.
NOTICE
This procedure is only applicable for the automatic unit conversion modes
AUTO-VOL and AUTO-MASS.
ACTION
1. Press the ► button
until the FLOWRATE
menu shows.
2. Press the ▲ button until
the UNIT menu shows.
3. Press the PROG button
momentarily.
4. Press the ▲ button to
make the required
selection.
5. Press the PROG button
momentarily.
6. Press the ▲ button until
the TIME menu shows.
7. Press the PROG button
momentarily.
8. Press the ▲ button to
make the required
selection.
9. Press the PROG button
momentarily.
10. Press the ▲ button until
the DECIMALS menu
shows.
11. Press the PROG button
momentarily.
12. Press the ▲ button to
make the required
selection.
13. Press the PROG button
momentarily.
DSY-UM-02266-EN-02_B3100 Automatic Unit Converter Tutorial.docx
RESULT
• The FLOWRATE menu
shows
• The UNIT menu shows.
• The PROG indicator
comes on.
• The selection US GAL
shows.
• The PROG indicator
goes off.
• The selection is
confirmed.
• The TIME menu shows.
• The PROG indicator
comes on.
• The selection /sec
shows.
• The PROG indicator
goes off.
• The selection is
confirmed.
• The DECIMALS menu
shows.
• The PROG indicator
comes on.
• The selection 0.1 shows.
• The PROG indicator
goes off.
• The selection is
confirmed.
N
OTICE
Now you can set the FLOWRATE
settings, but not the K-Factor
(decimals) because these settings
are controlled by the FLOWMETER
settings.
-
Now you can set the measurement
unit for display purpose only..
For the explanation,
the measurement unit for the flow
rate is set to US GAL.
The Flowmeter (K-factor) unit m
automatically converted to show the
total in US Gallons.
-
Now you can set the time unit for
display purpose only.
For the explanation,
the time unit for the flow rate is set
to /sec.
The flow rate is shown in the
selected period of time.
-
Now you can set the decimal
pointer for display purposes only.
For the explanation,
the decimals for the flow rate are
set to 1 decimal.
-
Page 11
is
3