Maintenance; Troubleshooting - GARANT 412780 Instruction Manual

GARANT Digital caliper HCT
de
6.3.3. Bluetooth profiles
Use without an app (HID)
Windows, macOS, Linux
en
Android, iOS
6.4. MENU
cs
C
 (1) Display set zero point:
Press MENU, press SET.
da
 (2) Unit of measurement:
1. Press MENU 4×.
» The active setting (MM or INCH) is displayed.
es
2. Press SET to change the unit of measurement.
» Press DATA to acknowledge.
fi
 (3) Setting the zero point:
1. Press MENU 2×, press SET.
» Set the SET value to between 0 and 9; press MENU to skip to the next place.
fr
» Press DATA to acknowledge.
 (4) Bluetooth mode / RESET / MAC address:
1. Press MENU 3×, press SET, to activate Bluetooth on the HID (PC connection).
hr
2. Press SET to de-activate Bluetooth.
3. Press SET to break the Bluetooth connection (RESET).
4. Press SET to display the MAC address of the connected Bluetooth device
hu
» Press DATA to acknowledge.
 (5) Setting the current value as the zero point:
Press SET and MENU simultaneously for longer than six seconds.
it
7.

Maintenance

Interval
lt
According to individual requirements
7.1. CHANGING THE BATTERY
1. Pry open the battery compartment carefully with a slot-head screwdriver.
nl
2. Replace CR2032 battery (positive terminal pointing upwards).
3. Insert battery compartment and press into casing.
8.

Troubleshooting

pl
Fault
Cannot establish a connection to the
caliper.
ro
Error message on the display: Err.bt2
ru
9. Cleaning
sl
Remove dirt using a soft clean dry cloth. After contact with liquids, dry mechanical parts well. Do not use chemical, alco-
holic, abrasive or solvent-based cleaning agents.
10. Storage
sv
Store in the original box at temperatures between -10°C and +60°C. Do not store close to corrosive or aggressive chemical
substances, solvents, heat, moisture or dirt.
11. Technical data
zh
Frequency band
12
Use with an app (APP)
-
Android, iOS
Maintenance work
Recalibration according to A1 Cal
Possible causes
When using the caliper for the first time
it may take two or three attempts be-
fore the connection is established.
Configuration of the Bluetooth module
has malfunctioned.
2.4 GHz
To be performed by
Hoffmann Group Customer Service
Action
C
See the diagram no. 5 for RE-
SET.
1. Briefly press any key.
2. Repeat the procedure or perform
RESET.