Table of Contents
Advertisement
UPS5000-E-(60 kVA-125 kVA)
User Manual (Integrated UPS 3.0)
Step 2 Use a hammer drill to drill holes for installing expansion bolts and then install
expansion bolts in the holes.
Figure 3-7 Expansion bolt composition
(1) M12 bolt
Knock the expansion bolt into the hole until the expansion sleeve completely fits
into the hole. The expansion sleeve must be completely buried under the ground
to facilitate subsequent installation.
Figure 3-8 Installing an expansion bolt (unit: mm)
1.
2.
Issue 04 (2022-12-30)
(2) Spring washer
NO TICE
Drill a hole into the concrete floor using a hammer drill. The hole depth
ranges from 52 mm to 60 mm.
Slightly tighten the expansion bolt and vertically insert it into the hole. Knock
the expansion bolt using a rubber mallet until the expansion sleeve is fully
inserted into the hole.
Copyright © Huawei Digital Power Technologies Co., Ltd.
(3) Flat washer
3 Installation
(4) Expansion sleeve
72
Advertisement
Table of Contents
