Safety Information For The Operator/User; Safety Information For Maintenance, Inspection And Installation; Unauthorised Modes Of Operation - Delta V3 Installation And Operating Manual

2.6 Safety information for the operator/user
• Fit protective equipment (e.g. contact guards) supplied by the operator for
hot, cold or moving parts, and check that the equipment functions properly.
• Do not remove any protective equipment (e.g. contact guards) during
operation.
• Provide the personnel with protective equipment and make sure it is used.
• Contain leakages (e.g. at the shaft seal) of hazardous fluids handled
(e.g. explosive, toxic, hot) so as to avoid any danger to persons and the
environment.Adhere to all relevant laws.
• Eliminate all electrical hazards. (In this respect refer to the applicable
national safety regulations and/or regulations issued by the local energy
supply companies.)
• If shutting down the pump does not increase potential risk, fit an
emergency stop control device in the immediate vicinity of the pump (set)
during pump set installation.
• Make sure the system cannot be accessed by unauthorised persons (e.g.
children).
2.7 Safety information for maintenance, inspection and
installation
• Modifications or alterations of the pump (set) are only permitted with the
manufacturer's prior consent.
• Use only original spare parts or parts/components authorised by the
manufacturer. The use of other parts/components can invalidate any
liability of the manufacturer for resulting damage.
• The operator ensures that maintenance, inspection and installation are
performed by authorised, qualified specialist personnel who are thoroughly
familiar with the manual.
• Only carry out work on the pump (set) during standstill of the pump.
• Only perform work on the pump set when it has been disconnected from
the power supply (de-energised).
• The pump (set) must have cooled down to ambient temperature.
• Pump pressure must have been released and the pump must have been
drained.
• When taking the pump set out of service always adhere to the procedure
described in the manual. (
• Decontaminate pumps which handle fluids posing a health hazard.
• As soon as the work has been completed, re-install and re-activate any
safetyrelevant devices and protective devices. Before returning the
product to service, observe all instructions on commissioning.
2.8 Unauthorised modes of operation
Never operate the pump (set) outside the limits stated in the data sheet and in
this manual.
The warranty relating to the operating reliability and safety of the supplied pump
(set) is only valid if the equipment is used in accordance with its intended use.
( Section 2.2, Page 7)
 
Delta V3, V4, V6 Submersible Pump
Section 6.3, Page 21)
 
2 Safety
Installation and operating manual 9 of 32