Advertisement
Figure1
3. Commissioning
WARNING
Unauthorized voltage or frequency!
Risk of accident
The mains voltage and the frequency of the power source must correspond
with the specifications on the machine's name plate.
4. Operating instructions
4.1 The tool is intended to be operated as a hand held tool. The tool can be
used in any position. Note! The sander can develop a torque reaction when
started.
4.2 Make sure the sander is switched off. Select a suitable abrasive and
secure it to the backing pad. Make sure the abrasive is centered on the
sanding pad. For optimal performance we recommend original sanding pad
and Sanding paper.
4.3 Switch on the sander by pressing the On/Off key,
4.4 The sander can now be started by pressing the lever.
4.5 The speed can be adjusted between 4,000 and 10000 rpm by rpm+ and
rpm-. Each press increases or reduces the speed by 1,000 rpm until it reaches
the limits.
4.6 When sanding, always place the tool on the work surface before starting
the tool. Always remove the tool from the work surface before stopping it. This
will prevent gouging of the work surface due to excess speed of the abrasive.
08
Advertisement
