Table of Contents
Advertisement
WATT PROGRAM :
1. Turn on the console
To turn on the console, press any button on the
console or simply begin pedaling.
2.Select your preset program
Press the UP and DOWN button to select program
11. Wait until the word PROGRAM begins flashing.
Press the ENTER button to validate.
3.Entering your datas
TIME will flash, press the UP and DOWN button to
select your TIME, then press the UP and DOWN
button to select your DISTANCE and WATTS. Press
the ENTER button to validate. FInally, press START/
STOP to start.
This program depends on your speed, as a
consequence, you cannot adjust your resistance
level.
4. Change the resistance of the pedals as
desired.
As you pedal, change the resistance of the pedals
by pressing the Resistance increase and decrease
buttons. There are ten resistance levels. Note: After
you press the buttons, it will take a moment for the
pedals to reach the selected resistance level.
5. When you are finished exercising, the console
will turn off automatically.
If the pedals do not move for a few seconds, the
time will flash in the display and the console will
pause. If the pedals do not move for a few minutes,
the console will turn off and the display will be reset.
HEART RATE CONTROL PROGRAMS :
1. Turn on the console
To turn on the console, press any button on the
console or simply begin pedaling.
2.Select your preset program
Press the UP and DOWN button to select program
12 to 15. Wait until the word PROGRAM begins
flashing. Press the ENTER button to validate.
Each program corresponds to a specific target :
Program 12 you define your HRC traget
Program 13 corresponds to 60% of Max HRC
Program 14corresponds to 70% of Max HRC
Program 15 corresponds to 80% of Max HRC
The HRC is calculated as follow : 220- your age. For
instance, for a person of 35 years old : 220-35 = 185
pulse/min.
3. Entering your datas
AGE will flash, press the UP and DOWN button to
select your AGE, then press the UP and DOWN
button to select your target, then press ENTER to
validate.
Do as before, to set up TIME, DISTANCE and
CALORIES. FInally, press START/STOP to start.
4. Change the resistance of the pedals as
desired.
As you pedal, change the resistance of the pedals
by pressing the Resistance increase and decrease
buttons. There are ten resistance levels. Note: After
you press the buttons, it will take a moment for the
pedals to reach the selected resistance level.
5. When you are finished exercising, the console
will turn off automatically.
If the pedals do not move for a few seconds, the
time will flash in the display and the console will
pause. If the pedals do not move for a few minutes,
the console will turn off and the display will be reset.
8
Advertisement
Table of Contents
