Table of Contents
Advertisement
USER SETTING PROGRAMS :
1. Turn on the console
To turn on the console, press any button on the
console or simply begin pedaling.
2.Select your preset program
Press the UP and DOWN button to select program
16 to 19. Wait until the word PROGRAM begins
flashing. Press the ENTER button to validate.
3.Entering your datas
Users are free to edit the values in the order of
TIME, DISTANCE, CAL, AGE, and the level of
resistance in 10 intervals. The values and profiles
will be stored in the memory after setup.
To do that, once the program is selected and yo
pressed the ENTRE button, the first column will be
flashing and you'll use the UP and DOWN button
to create your profile. Press ENTER to validate,
you'll then move on the 2nd column. Do the same
as before for the 10 columns. Finally press START/
STOP button to start.
4. Change the resistance of the pedals as
desired.
As you pedal, change the resistance of the pedals
by pressing the Resistance increase and decrease
buttons. There are ten resistance levels. Note: After
you press the buttons, it will take a moment for the
pedals to reach the selected resistance level.
If the pedal do not move for a few seconds, the word
STOP will appear in the display, and the console will
pause. The console has an "auto-off" feature. If the
pedals do not move and the console buttons are not
pressed for a few minutes, the power will turn off
automatically to save the batteries.
BODYFAT PROGRAMS :
1. Turn on the console
To turn on the console, press any button on the
console or simply begin pedaling.
2.Select your preset program
Press the UP and DOWN button to select program
8. Wait until the word PROGRAM begin flashing.
Press the ENTER button to validate. Program 8 is a
special program designed to calculate users' body
fat ratio and to design a specific loading profile for
users.
3.Entering your datas
With 4 different body types, the computer can
generate 4 different profiles for each. Press
"ENTER" key to select GENDER, HEIGHT WEIGHT,
and AGE. Then, press UP or DOWN button to adjust
the values. After pressing "START/STOP" key to
calculate body fat, please also apply the heart rate
detector appropriately. If the detector cannot pick
up any signals, an error message "Err" will show up
in the profile display. If it happens, press "START/
STOP" key to calculate again. Then, the calculation
values of FAT%, BMR, BMI, BODY TYPE, and a
designed profile will show up shortly. Press "START/
STOP" key to exercise. The profile shown in the
display is specially designed for your body type.
4. Start pedaling and change the resistance of
the pedals as desired.
As you pedal, change the resistance of the pedals
by pressing the resistance increase and decrease
buttons. There are ten resistance levels. Note: After
you press the buttons, it will take a moment for the
pedals to reach the selected resistance level.
5. When you are finished exercising, the console
will turn off automatically.
If the pedals do not move for a few seconds, the
time will flash in the display and the console will
pause. If the pedals do not move for a few minutes,
the console will turn off and the display will be reset.
9
Advertisement
Table of Contents
