Maintenance - K&S BASIC KSB 1200C Owner's Manual

Fuel valve
Closed
Open
1. Move the fuel valve to the "OPEN" position.
2. Set the air choke to the closed position.
3. For elektrostart generators - turn the key in the «START» position and hold in that position for several seconds
before starting the engine.
4. To start the generator manually, grasp the starter handle and slowly pull it until resistance is felt. Pull the starter
cord to the full length with a sharp movement.
5. Set the air choke to the "OPEN" position.
STOPPING THE ENGINE STOPPING THE ENGINE
WARNING - DANGER!
1. Disconnect all power consumers from the generator, set the safety switch to the OFF position.
2. Allow the generator to operate at idle for 3 minutes so that the alternator cools down.
3. In case of manual start, set the engine switch to OFF.
4. In case of electric start, set the key to OFF.
5. Move the fuel valve to the "CLOSE" position.
Works, specified in "Technical maintenance" section, are to be regularily performed. If the the generator user has
no possibility to perform regular maintenance independently, it is necessary to address the official service center to
registrate an order for such works performance.
You can find a list of service center addresses in your warranty card.
IMPORTANT!
SUCH DAMAGES ARE ALSO: SUCH DAMAGES ARE ALSO:
- Damages occurred as a result of using non original spare parts.
- Corrosion damages and other results of improper equipment storage.
- Damages occures as a result of maintanance performance by inexperienced and unauthorized specialists.
IMPORTANT!
FIRST OF ALL THIS APPLIES TO: FIRST OF ALL THIS APPLIES TO:
- Use of lubricants, gasoline and motor oils, forbidden by the manufacturer.
- Device technical alterations.
- Equipment operations against its intended use.
- Indirect damages, caused by operating faulty equipment.
Hand starter
DISCONNECT ALL THE DEVICES BEFORE STOPPING THE GENERATOR!
Do not stop the generator, if there are connected devices.
This may lead generator down!
In case of any damages, occurred due to non-performance
of regular maintenance works, the manufacturer bears no
responsibility for such damages.
MANUAL COMPLIANCE
Technical maintanance, operation and K&S Basic™ generator storage
are to be performed according to this manual recommendations.
Manufacturer bears no responsibility for damages and losses,
caused by incompliance to safety requirements and technical
maintanance rules.
Air choke
OPEN
closed open CLOSE

MAINTENANCE

konner-sohnen.com
6
| 7