Maintenance - K&S BASIC KSB 10i Owner's Manual

Inverter generator
Table of Contents

Advertisement

IN THE FIRST 20 OPERATING HOURS OF THE GENERATOR, THE FOLLOWING REQUIREMENTS SHOULD BE MET:
IN THE FIRST 20 OPERATING HOURS OF THE GENERATOR, THE FOLLOWING REQUIREMENTS SHOULD BE MET:
1. During commissioning, do not connect power consumers, the power of which exceeds 50% of the nominal (operating)
power of the device.
2. Check and clean the air filter, fuel filter and spark plug.
ENGINE START
ENGINE START
- Do not connect the generator to the load before you start the engine.
- Do not let the fuel mixture flow and do not use instruments to facilitate the launch.
- Provide ventilation and beware of fire and sparks.
1. Put the engine switch in "ON" position.
2. Press the hand pump 3-5 times. Press until gasoline starts to flow from a transparent plastic tube.
3. For manual start, pull the manual starter until a slight resistance is felt, then pull it toward you relatively sharply.
Slowly turn the manual starter by hand, do not release it abruptly.
5. After starting the generator - heat the engine until it starts to work steadily with closed air dampers.
6. Turn leaver air flaps in position "OPEN".
IMPORTANT!
- Before connecting the load, allow the engine to run for 1-2 minutes to warm it up.
- When disconnecting the load after lengthy operation, do not turn off the generator. Allow the generator
to run idle for 1-2 minutes so that it cools down.
DISCONNECT ALL DEVICES BEFORE STOPPING THE GENERATOR!
DISCONNECT ALL DEVICES BEFORE STOPPING THE GENERATOR!
Do not stop the generator with the devices turned on. This may disable the generator or devices connected to it!
TO STOP THE ENGINE, PROCEED AS FOLLOWS:
TO STOP THE ENGINE, PROCEED AS FOLLOWS:
1. Disconnect all electric devices.
2. Let the generator run at no load for 1-2 minutes for alternator to be cooled.
3. Set the engine switch to position "OFF".
This manual compliance! You can find a list of service center addresses on the website of exclusive importer:
www.ks-power.de/en
Check /Cleaning
Air filter
Replacement
Cleaning
Spark plug
Replacement
Level check
Fuel tank
Cleaning
Useful tip: to ensure long-term operation of the generator engine, it
is important to observe the following tips:
TECHNICAL MAINTENANCE WORKS

MAINTENANCE

www.ks-power.de/en
8
| 5

Advertisement

Table of Contents
loading

Table of Contents