Maintenance - K&S BASIC KSB 22i S Owner's Manual

TO STOP THE ENGINE, PROCEED AS FOLLOWS:
1. Turn off all devices.
2. Allow the generator to run idle for approx. 1-2 minutes.
3. Set the engine switch to the "OFF" position.
4. Turn the air choke control knob to the "OFF" position (fig. 4).
5. Allow the generator to cool down.
6. Unplug the devices.
7. After the generator stops, allow it to cool down and close the air vent on
the fuel cap (set to OFF, as shown in fig. 3).
IMPORTANT!
If the DC protector turns off again, stop the battery charging process because the current of the operating electrical
device is higher than the rated current. Do not charge batteries if their current consumption is higher than 8.3 A (de-
pending on the generator model).
ATTENTION – DANGER!
This manual compliance! You can find a list of service center addresses on the website of exclusive importer:
www.konner-sohnen.com
Level check
Motor oil
Replacement
Check /Cleaning
Air filter
Replacement
Cleaning
Spark plug
Replacement
Level check
Fuel tank
Cleaning
Fuel filter
Check (clean out)
Inverter generators from K&S BASIC
teries with an operating voltage similar to conventional lead-acid bat-
teries. When the generator is running, the battery is charged automat-
ically. If it is necessary to charge the battery with an external device,
we recommend using the KS B1A charger or the charger for charging
lead-acid motorcycle batteries with a nominal voltage of 12V with a
charge current of not more than 2A.
Never smoke or interrupt battery connections to the generator while
the battery is being charged.
TECHNICAL MAINTENANCE WORKS
® are equipped with lithium bat-

MAINTENANCE

konner-sohnen.com
Fig. 3
Fig. 4
9
| 8