K&S BASIC KSB 1200C Owner's Manual page 6

9 1
8
7
6
5
4
1. Fuel cap
2. Control panel
3. Oil dipstick
4. Oil drain cap
IMPORTANT!
1. Voltmeter or LED display
(for models KSB 3500C and KSB 6500CE)
2. Safety switch
3. Outlets
4. Engine start button (ON/OFF) or key for electric
start (for model KSB 6500CE)
5. 12V/8A DC outlet
6. Ground connector
1. Fill the crankcase with engine oil. The recommended amount of oil for each model is indicated in the specification
chart.
2. Check oil level with an oil dipstick. It should be between the MIN and MAX marks on the oil dipstick.
3. Check fuel level.
4. Check the air filter for correct installation
In the first 20 operating hours of the generator, the following requirements should be met:
1. During commissioning, do not connect power consumers, the power of which exceeds 50% of the nominal
(operating) power of the device.
2. After the first 20 operating hours, be sure to change the oil. It is better to drain oil while the engine is still hot after
operation to ensure quick and complete oil draining.
3. Check and clean the air filter, fuel filter and spark plug.
To commission the generator, follow the maintenance recommendations for the first month or twenty hours of
operation (whichever comes first) contained in the "Maintenance" section.
For commissioning models with elektrostart please charge the battery. Please use additional battery charger (not
included) to charge the battery or let the generator work at least one hour at 50% load at the first start.
GENERAL VIEW AND COMPOSITION
OF THE GASOLINE POWERED GENERATOR
2
11
3
5. Hand starter
6. Fuel valve
7. Air filter
8. Air choke lever
The manufacturer reserves the right to make changes in the
product design, configuration and construction. Illustrations in
this manual are for reference only and may differ from actual
components and inscriptions on the products.
10
9. Fuel level indicator
10. Damper
11. Alternator
12. Spark plug
1 2
4 5
COMMISSIONING
konner-sohnen.com
3
12
3
6
4
| 5