K&S BASIC KSB 1200C Owner's Manual page 10

ATTENTION - DANGER!
TO DRAIN OIL, PROCEED AS FOLLOWS: TO DRAIN OIL, PROCEED AS FOLLOWS:
1. Place the generator on a flat surface and warm up the engine for several minutes.
Stop the engine and turn the fuel tank cap to the "OFF" position.
2. Loosen the screws and remove the motor cover.
3. Place an oil drain tray under the engine.
4. Unscrew the oil drain cap with a hexagon key.
5. Wait for the oil to drain. Tilt the generator for a better result.
6. Add motor oil to a high level.
7. Wipe the oil drain cap with a clean, dry cloth and wipe off any oil spills, if any.
Make sure that no dirt, dust, etc. are caught in the crankcase.
8. Replace the oil filler cap.
9. Replace the vent cover and tighten the screws.
ATTENTION - DANGER!
Spark plug is an importaint element providing the correct engine
operation. It has to be intact, without soot deposits and to have a
correct gap.
SPARK PLUG INSPECTION: SPARK PLUG INSPECTION:
1. Remove the cap from the spark plug.
2. Remove the spark plug by means of a corresponding spanner.
3. Examine the spark plug.
If it is shattered – it is necessary to replace it. Recommended replacement
spark plugs – F7TC.
4. Measure the gap. It has to be within range 0.7 – 0.8 mm.
5. Place the spark plug in its place by means of a spark plug spanner.
6. Replace the spark plug cap.
It is necessary to check the air filter from time to time and clean any contaminations.
Regular air filter maintenance is necessary to maintain sufficient carburetor air inflow.
Avoid draining the engine oil immediately after stopping the
engine. The oil is hot and should be handled with care to avoid
burns.
Do not tilt the generator while adding oil to the engine. This can
lead to overfilling and damage to the engine.
SPARK PLUG TECHNICAL MAINTENANCE
AIR FILTER TECHNICAL MAINTENANCE
CLEANING THE FILTER: CLEANING THE FILTER:
1. Open the air filter cover.
2. Remove the sponge filtering element.
3. Remove all dirt deposits inside the hollow case of the air filter.
4. Thoroughly wash the filtering element in warm water.
5. Dry the sponge filter.
6. Dry filtering element is to be moistened by machine oil and excess oil
is to be squeezed out.
Electrode
0,7-0,8 mm
Spark plug
konner-sohnen.com
8
9
| 9