Meter Configuration And Update - Landis+Gyr E450 User Manual

44/54
5.3

Meter Configuration and Update

© Landis+Gyr
Value
Maximum demand A+, rate x
Maximum demand A-
Maximum demand A-, rate x
Maximum demand R+
Maximum demand R+, rate x
Maximum demand R-
Maximum demand R-, rate x
Power factor
Network frequency
Current L1
Voltage L1
Utility serial number 1 (ID2.1)
Utility serial number 2 (ID2.2)
Utility serial number 3 (ID2.3)
Utility serial number 4 (ID2.4)
IO control signal status register
Internal Control Status register
Internal operating status
Number of power failures in all phases
Number of long power failures in any phase
Number of power failures in any phase
Operating time
Operating time, rate x
where x is the number of the corresponding rate (range 1 ... 6)
The initial configuration of the meter is defined when ordering the meter at
Landis+Gyr. Configuration files can be uploaded to the AMM system for
automatic configuration after the meter is installed to the system.
The configuration ID can be read from the meter by the metering system.
Later configuration of parameters and updates can be done remotely from
the AMM system, or locally through the optical port using the .MAP120
Parameter Editor (see also .MAP120 Parameter Editor and AMM system
documentation).
Displayed
OBIS Code
13.7.0
31.7.0
32.7.0
D000029326 en g – E450 PLC 1-phase ZCX100Px – User Manual
Operation
1.6.x
2.6.0
2.6.x
3.6.0
3.6.x
4.6.0
4.6.x
14.7.0
C.1.0
C.1.1
C.1.2
C.1.3
C.3.0
C.4.0
C.5.0
C.7.0
C.7.9
C.7.21
C.8.0
C.8.x