Landis+Gyr E450 User Manual page 30

30/54
PLC device commu-
nication status
MAC address
Initiator MAC address
Reset PLC
© Landis+Gyr
The Plcxxx.xx indication displays the PLC device communication status,
where xxx.xx has the meaning shown in the following table:
Display (value field)
The MAC address indication displays the OBIS code (hex coded with 3
characters i.e. "FFE") together with MAcAddr in the value field.
The Initiator MAC address indication displays the OBIS code (Hex coded
with 3 characters i.e. "FFE") together with IMAcAddr in the value field.
When pressing the display key for > 2 seconds, the meter will be set to
PLC NEW state, i.e. the data concentrator and the meter get "un-bundled".
The PLC device communication status is displayed again afterwards.
Description
Error (no information from PLC chip – failure).
Meter is not synchronised to the 50 Hz mains, the meter
at this time is not registered at data concentrator & data
concentrator is also still unknown (unlocked) – coldstart
state when no DC in the network.
Meter is not synchronised to the 50 Hz mains and meter
is not registered at data concentrator but data
concentrator known (locked).
Meter is not synchronised to the 50 Hz mains but meter
is registered at data concentrator.
Meter is synchronised to the 50 Hz mains and meter is
not registered at data concentrator, data concentrator
unknown (unlocked).
Meter is synchronised to the 50 Hz mains and meter not
registered at data concentrator but data concentrator
known (locked) – synchronisation in progress.
Meter is synchronised to the 50 Hz mains and meter is
registered at data concentrator – Correct installation!
D000029326 en g – E450 PLC 1-phase ZCX100Px – User Manual
Installation