Device Information Query; Network Status Query - H3C VG 10-10 User Manual

User Manual
H3C VG 10-10/10-11 Voice Gateway
Table 4-7 Management IP address configuration
Configuration
item
Management IP
address
Management
address subnet
mask
Caution:
When using management IP address to log into the voice gateway, make sure that
this IP address is not used by other network devices or PCs simultaneously in the
same network environment. In the user network, the management IP address of the
voice gateways can be the same, and no collision will occur.
You are authorized to modify the management IP address only when you log in as
an admin user.
The voice gateway does not allow the interface IP address and the management IP
address to be configured in the same network segment; and it does not allow the
existence of overlapping addresses. If the IP address that can be obtained
dynamically by the voice gateway is in the same network segment with the
management IP address, the dynamically obtained IP address fails.

4.5 Device Information Query

4.5.1 Network Status Query

Select "Status -> Network" in the navigation bar to enter the network status query page.
You can view the link state, negotiation mode, speed and duplex mode of the two
Ethernet ports.
Description
You can use this IP
address to log into
the voice gateway
and configure the
system parameters
through LAN port.
Management IP
address subnet
mask
4-18
Chapter 4 VG Configuration
Caution Default value
- 192.168.192.1
You need to
configure the
subnet mask
after
255.255.255.0
configuring
the
management
IP address.
Type
Required
Required