Table of Contents
Advertisement
Electrical connection
8.3 System integration
8.3.5.4
Signal cables
Signal cables for the motor
Use prefabricated cables to connect motors.
Table 8- 18
Example of the article number structure for a prefabricated cable
Description
DRIVE-CLiQ signal cable (example)
MOTION-CONNECT 500
MOTION-CONNECT 800 PLUS
Connectors mounted on both sides
Loosely enclosed connector for the module side
Loosely enclosed connector for the motor end
1) Detailed information on the structure of the length code can be found in the catalog, see link below.
Detailed information on the signal cables is provided in Chapter "Chapter, "MOTION-
CONNECT connection systems" in Catalog D 21.4
mc/de/motion-control/support/infomaterial/kataloge/d-21-4-sinamics-s120-simotics/Seiten/d-
21-4.aspx)".
8.3.5.5
Connecting the signal cable on a force-ventilated motor
The signal connection of the force-ventilated motor is located under the fan cover or in the
intermediate flange, and cannot be seen.
The signal connection can be as shown below:
You must remove the fan cover or the intermediate flange to connect the signal cable. To
remove the fan cover or the intermediate flange when the motor is installed, you need a
minimum clearance s at the NDE.
394
Position of the article number
1
2
6
F
DRIVE-CLiQ
Connector variants
Length code
with DRIVE-CLIQ
RJ45 via Sensor Module
3
4
5
6
7
-
X
5
8
0
0
2
1
2
4
2
-
1)
(https://intranet.for.siemens.com/org/i-dt-
Round connector M17
Configuration Manual, 09/2018, A5E45099423B AA
8
9
10 11 12 - 13 14 15 16
2
D
❑
❑
❑
-
Without DRIVE-CLiQ
Round connector M23
S-1FT7 synchronous motors
❑
❑
❑
❑
Advertisement
Table of Contents
