Restarting, Resetting And Upgrading The Fbxi; Resetting The Webui Login - ABB Cylon FBXi Series User Manual

RESTARTING, RESETTING AND UPGRADING THE FBXi

The FBXi controller can be restarted or reset using the two buttons located on the front panel (under the
flap) marked and
SW1
signal the progress of the reset or upgrade:

RESETTING THE WEBUI LOGIN

If the username / password or
WebUI
log in to the , you can reset them to known values, i.e. the Factory defaults:
WebUI
•
username:
•
password:
•
IP address: based on serial number (see
To reset the IP address
and then release
SW1
FULL FACTORY RESET
To restore all settings in the FBXi, including any strategy configuration, the shipped version of firmware,
controller IP address and the
until the LED lights up, and then release
During Factory reset, LED
•
Slow blink:
•
Solid colour:
•
Fast blink:
UPGRADE FIRMWARE FROM USB
insert a FAT-formatted USB drive containing valid firmware (.swu) into either of the USB ports, while the
controller is booting hold
During USB upgrade, LED
•
Slow blink:
•
Solid colour:
•
Fast blink:
RESTARTING THE CONTROLLER WITHOUT POWER CYCLING
To restart the FBXi
LED L2 lights up, and then release
©ABB 2023 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
. Beside these buttons there are two LEDs marked
SW2
IP address
admin
cylonctl
Configuring the IP connection
and password, press
SW1
.
username / password : press
WebUI
.
SW1
will indicate the progress as follows:
L2
Reset in progress
Reset successful. Power-cycle the controller to activate.
Reset failed
SW1 until LED L1 lights up, then release SW1.
L1 will indicate the progress as follows:
Upgrade in progress
Upgrade successful. Power-cycle the controller to activate.
Upgrade failed
without disconnecting the power, press
SW2
FBXi Series |
have been changed to unknown values so that you cannot
while the controller is running, hold it until LED
while the controller is booting, hold it
SW1
while the controller is running, hold it until
SW2
FBXi Operation
and , which are used to
L1 L2
on page 39)
L2 lights up,
80