ABB Cylon FBXi Series User Manual page 42

Configuring the IP connection without CXproᴴᴰ
If your network does not have a
made up as follows:
• The first byte of the IP address is set to 10
• The 6 digits of the numerical part of the serial number grouped into 3 sets of 2 digits to form the last 3
bytes of the IP address.
For example, a FBXi
Note: For a laptop (or PC) to communicate with a
Ethernet port must be set to a subnet that is compatible with the FBXi's IP address.
For example, if the
like with a subnet mask of
10.90.10.nn
Note: If the default IP address is used on a network, it can cause an
subnet mask is
10.0.0.0/8
It may be possible to reach the FBXi over the network but BACnet messaging may fail.
In this case you may need to use a directly-connected laptop, or a different network to configure the
FBXi. Alternatively you could change the FBXi's
number) to reduce the size of the
serial number
901001A
©ABB 2023 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
DHCP server, then the
with serial number
901001A
FBXi
FBXi has an IP address of
10.90.10.01
255.255.255.0
Subnetwork (Subnet)
(see
subnet that could give rise to conflicts. For example, a
should have a subnet mask of
FBXi Series |
FBXi controller will use a default
will be allocated the default IP address of
configured in this way, the IP address of the laptop's
, the laptop could have an address something
.
IP Address conflict if the network's
on page 8).
subnet mask to
10.ss.ss.ss/24
.
10.90.10.01/24
Installation
IP address, which is
10.90.10.01
, (where is the serial
ss
FBXi with
42