ABB Cylon FBXi Series User Manual page 76

UniPut™ 24 V AC Detection
If 24 V AC is connected to a
switch . stays open for the duration of the 24 V AC state. When 24 V AC is removed from the
SW1 SW1
terminal then the short circuit or open circuit states can again be detected.
Voltage input mode (Active Input)
Universal Input
Note: Input Impedance for
Input Impedance for
The 0 ... 10 V input is used for Active analog and digital measurements. 'Active' means that there is no current
supplied by the FLX
The ' ' sensor setting gives a value between
mV
In
0 ... 10V Input
Current Input mode (Active Input)
Universal Input
The Current Input is used for
scaling can easily be achieved using
4 ... 20 mA
' ' parameters.
Advanced
©ABB 2023 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
Uniput™ terminal, then the
Uniput
Universal Input terminals is 130 kΩ.
Uniput™ terminals is 40 kΩ.
for the sensor, as the signal is generated completely by the Sensor.
0
Mode, the Uniputs™ configure like this:
Uniput
or
0 ... 20 mA 4 ... 20 mA
FBXi Series |
24 V AC Detect circuit will detect this and will open
and , which represents voltage in mV.
10,000
Active sensors.
CXproᴴᴰ by entering range values in the Point Module
FBXi Operation
Uniput™
76