Fig.13 Position For Coffee; Fig.14 Water Selector Components - BRAVILOR BONAMAT Aurora SINGLE LOW Operating Principle

A
B

Fig.13 Position for coffee

Operation of the water selector when starting to make coffee:
• When a selection is made, the water selector motor is controlled. When the hall sensor
(Fig.13, A) detects the magnets that are close together (Fig.13, B), the position for dosing on
the coffee is determined.
• After the position has been determined, the pump motor is controlled.
• The dosed hot water is pumped into the top of the water selector (Fig.14, A).
• The water runs through the central hole of the distribution disc (Fig.14, B). Then it exits through
the oblique hole at the bottom (Fig.14, C).
• Dependent on the recipe settings, the water selector can switch between dosing on the coffee
and dosing through the bypass. This can be done several times while making coffee.
Note:
► As soon as the water selector switches between dosing on the coffee or through the
bypass, the pump will be switched off until the water selector has determined its position
again.

Fig.14 Water selector components

8
A
B
C