Coffee Grinder; Replacing The Grinding Discs - BRAVILOR BONAMAT FRESHONE (G) Operating Principle

1.9

Coffee grinder

We recommend checking the coffee grinder and the coarseness of the ground coffee periodically and to
maintain the grinder according to the below table:
Coffee beans
After the first 30−50 kg:
After every 300 kg:
After every 1000 kg:
1.9.1

Replacing the grinding discs

1. Pull the plug from the socket.
2. Remove the drip tray.
3. Open the door with the provided key.
4. Open the cover.
5. Tear off the filter paper to just in front of the brewer.
6. Remove the roll of filter paper.
7. Close the bean supply, push the drawer back.
8. Remove the ingredient canister from the machine.
9. Loosen the two fastening screws on the cover plate and remove the cover plate.
10. Remove the coffee grinder by loosening the bolts (3x).
11. Mark the position of the lockpin [1].
12. Remove all coffee beans (hoover).
13. Remove the lockpin [1].
14. Loosen the flange [2] by turning it anticlockwise.
15. Remove the grinding disc by loosening the three screws [3] (on the moving and the static flange).
The moving flange [3a] must be held in place with a plastic tool.
16. Clean all parts thoroughly.
The grinding unit has now been removed and can be replaced. The new grinding disc must be
installed in reverse order.
Please note:
− The surfaces of the different components must be thoroughly cleaned before putting them back in the
machine. This is the only way to guarantee that the grinder will work properly.
− The grinding discs must not touch each other during installation.
− Calibrate (see § 1.9.2) after installation.
Fig. 23 Coffee grinder
10
Action:
Check the coarseness of the ground coffee
Clean the coffee grinder
Calibrate the coffee grinder if necessary
Replace the grinding discs