Supermicro SuperServer SSG-631E-E1CR16H User Manual page 56

NCSI Connector
The Network Controller Sideband Interface (NCSI) connector is located at JNCSI1. The
connector is used to connect a Network Interface Card (NIC) to the motherboard to allow the
onboard BMC to communicate with a network.
Note: For detailed instructions on how to configure Network Interface Card (NIC) settings,
please refer to the Network Interface Card Configuration User's Guide posted on the web
page under the link: http://www.supermicro.com/support/manuals/.
SATA 3.0 Ports
The X13DEI-T has two SATA 3.0 ports (I-SATA0~1) on the motherboard. These SATA ports are
supported by the Intel® C741 chipset. I-SATA0/1 can be used with Supermicro SuperDOMs
which are orange SATA DOM connectors with power pins built in, and do not require external
power cables.
A slim SAS connector, located at JS1, supports eight SATA 3.0 connections (SATA0~7) on the
motherboard. These SATA 3.0 ports are supported by the Intel® C741 chipset. Connecting
a proper SATA cable to JS1 to use SATA 3.0 connections.
DOM Power Connector
Two power connectors for SATA DOM (Disk-On-Module) devices are located at JSD1 and
JSD2. Connect appropriate cables here to provide power support for your Serial Link DOM
devices.
MCIO NVMe Connectors
MCIO NVMe connectors, located at P1_NVME0/1, P1_NVME2/3 and P2_NVME4/5, provide
six PCIe 5.0 x4 connections on the motherboard. P1_NVME0/1 and P1_NVME2/3 connections
are supported by CPU1. P2_NVME4/5 are supported by CPU2. Use these MCIO connectors
to support high-speed PCIe NVMe storage devices.
Note: When installing an NVMe device on a motherboard, please be sure to connect the first
NVMe port (P1_NVME0/1) first for your system to work properly.
Chapter 4: Motherboard Connections
DOM Power Connector
Pin Definitions
Pin# Definition
1 5V
2 Ground
3 Ground
56