Supermicro SuperServer SSG-631E-E1CR16H User Manual page 44

3. Connect cables to the PCB backplane. Route the cables into the chassis and through
the opening under the power supplies.
4. Insert the drive cage assembly into the chassis while carefully following the cables.
Secure the cage with screws through the bottom of the chassis.
4
Figure 3-9. Installing Rear Hot-Swap Drive Tray
5. Attach power and data cables to the power distributor and the motherboard.
6. Slide two 2.5" storage drives mounted in drive carriers into the tray.
Chapter 3: Maintenance and Component Installation
Figure 3-10 Inserting Rear Drives
44