Hisense I6421CB Instructions Manual page 18

PAN POSITION RECOGNITION WITH AUTOMATIC BRIDGING OF
COOKING ZONES
A1 A B C3 H
The sign will appear on the display unit for the rear field to indicate that the two cooking
zones are bridged.
• Set the desired cooking power for the bridged cooking zone.
• To change the bridged zone's cooking power later on, use the (H) or (I) key for the lower
cooking zone.
Note: The bridged zone does not allow the Rapid Boil setting P. Maximum available power
level is 9.
Automatic pan position recognition can be activated at any time for 10 seconds by pressing
the pan recognition key (C3). Automatic pan recognition and automatic cooking zone bridging
are only effective on the cooking zones that are not yet activated. The cooking zone bridge
function can be switched off by setting the power level to "0".
If there is no pan on the cooking hob:
- Switch on the hob. All cooking zones are set to »0«.
- Place the pan on any cooking zone. »0« starts to flash on the cooking zone with the pan.
Cooking zone power can be adjusted by pressing the (H) or (I) keys for the respective
cooking zone. The function automatically bridges the cooking zones depending on the pan
size.
- You may continue with the next pan, using the same procedure.
If the pan is already on the cooking hob:
- Switch on the cooking hob.
- »'0« will flash on the display unit of the cooking zone with the pan on it. Cooking zone power
can be adjusted by pressing the (H) or (I) keys for the respective cooking zone.
- If there are several pans on the cooking zone, the hob will automatically detect all pans and
»0« will flash on display units of all zones on which a pan has been placed.
Cooking zone power can be adjusted by pressing the (H) or (I) keys for the respective cooking
zone; then continue with the next cooking zone.
During the first 10 seconds, automatic pan recognition can also be deactivated in user settings
using the Au parameter. See chapter "User Settings".
The function can be used if the pan is already on the cooking hob or if the cooking hob is
empty.
18
(Only with some models.)
I H
Pan position recognition is activated
automatically 10 seconds after the appliance is
switched on.
If there is a pan on the hob, the pan
recognition function will recognise its position
and automatically bridge the cooking zones
depending on the size of the pan. Two
adjacent cooking zones can be merged into a
I
single large cooking zone.