Firmware Upgrades Using The Service Support Tool - Canon imageRUNNER ADVANCE DX C357iF Series Service Manual

Canon
J. Firmware Upgrades Using the Service Support Tool
The SST (Service Support Tool) (version 4.81 or later) is available via
Canon's e-Support Center Website (http://www.support.cusa.canon.com) for
upgrading the following system components:
• System Software stored on the HDD
• Main engine firmware
• Accessory firmware (Refer to the SST User Manual for a list of supported
devices and accessories.)
• MEAP Contents
• Language
• HDD Format
• Clear the service mode password
• Initialize the HDD Encryption Board
• Temporary backup and restore the Flash PCB (Printed Circuit Board) and
SRAM settings on the Main Controller PCB 2.
• Initialize the standard area on the Flash PCB
The imageRUNNER ADVANCE DX C357iF Series devices support firmware
downloads from the SST and a USB memory stick. When the hard disk drive
is replaced, the SST is used to format the new HDD and load software.
IMPORTANT
• The imageRUNNER ADVANCE Security Kit-AQ1 for IEEE 2600.1 Common
Criteria Certification ships with certified device firmware to enable the
imageRUNNER ADVANCE DX C357iF Series machines to be IEEE 2600.1
certified.
• Once the imageRUNNER ADVANCE Security Kit-AQ1 for IEEE 2600.1
Common Criteria Certification is installed, you can only upgrade
imageRUNNER ADVANCE DX C357iF Series machines with firmware
versions certified for the IEEE standard 2600.1-2009. Upgrading to
non-certified firmware invalidates the IEEE standard 2600.1 certification,
although the machine will continue to operate properly.
imageRUNNER ADVANCE DX C357iF Series Service Guide
Revision 8
imageRUNNER ADVANCE DX C357iF Series Service Guide
March 2023
Page 57