Symbols Used; In The Documentation; Warning Notices - Structure And Meaning; Symbols In This Documentation - Bosch FSA 500 Instructions Manual

1.

Symbols used

1.1

In the documentation

1.1.1

Warning notices - Structure and meaning

Warning notices warn of dangers to the user or
people in the vicinity. Warning notices also indicate
the consequences of the hazard as well as preventive
action. Warning notices have the following structure:
KEY WORD – Nature and source of hazard!
Warning
Consequences of hazard in the event of
symbol
failure to observe action and information
given.
¶
Hazard prevention action and information.
The key word indicates the likelihood of occurrence and
the severity of the hazard in the event of non-observance:
Key word Probability of
occurrence
DANGER Immediate
impending danger
WARNING Possible impending
danger
CAUTION Possible dangerous
situation
1.1.2

Symbols in this documentation

Symbol Designation Explanation
! Attention Warns about possible property damage.
Information Practical hints and other
i
useful information.
1. Multi-step Instruction consisting of several steps.
2. operation
One-step Instruction consisting of one step.
e
operation
Intermediate An instruction produces a visible
�
result intermediate result.
Final result There is a visible final result on
"
completion of the instruction.
1.2

On the product

!
Observe all warning notices on products and
ensure they remain legible.
Attention is to be paid to these operating instructions
as well as all the technical documentation for the
diagnostic device and the part of the tester set used!
Robert Bosch GmbH
Severity of danger if
instructions not observed
Death or severe injury
Death or severe injury
Minor injury
Symbols used | FSA 500 | 19 |
DANGER – Risk of electric shock if
measurements are taken on motor vehicles
without battery B– cable!
Measurements taken with connecting cable
B– not connected to vehicle ground or
the battery negative terminal will result in
injury, heart failure or fatal electric shocks.
¶
Connect the FSA 500 by way of battery
B– cable to vehicle ground or the negative
post of the battery.
¶
Heed the following connection sequence.
Caution!
1. Switch off the ignition.
2. Connect FSA 500 to battery (B–) or engine ground.
3. Switch on the ignition.
Caution!
1. Switch off the ignition.
2. Disconnect the FSA 500 from the battery (B–) or engine
ground.
DANGER – Risk of electric shock from
excessively high measurement voltage!
The measurement of voltages in excess of
200 V using CH1 / CH2 multi measurement
cables will result in injury, heart failure or
fatal electric shocks.
¶
CH1 / CH2 multi measurement cables are
only to be used for measuring voltages up
to max. 200 V.
¶
Never use CH1 / CH2 multi measurement
cable to measure mains or similar voltages.
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
en
|
1 689 989 411 2023-03-24