Table of Contents
Advertisement
3.2.1
Assembly the slide rails on the modular belt conveyor
Quick installation guide_Conveyor system MB-flex S Al_20221114_EN.docx
1. Clip the slide rails (2) onto the chassis profile.
2
2. Check the slide rail for damage.
Only use undamaged slide rails.
3. Chamfer the slide rail at the start (viewed in running
direction).
4. Clip slide rail onto the chassis profile with the nose on
the underside (see Figure).
5. Clip slide rail onto the chassis profile in the running
direction with the assembly tool.
Avoid the development of "waves" in the slide rail by
6. Mount the slide profile seams with a gap of approx.
2 mm and offset.
7. Cut the slide profiles at an angle in the running
direction.
8. Gently deburr the butt ends.
9. Always mount the slide profiles over the seams of the
chassis profile.
clipping it on completely (audibly).
Assembly
11
Advertisement
Table of Contents
