Table of Contents
Advertisement
12
Assembly
Fig. 3: Assembly the slide rails on the modular belt conveyor
Quick installation guide_Conveyor system MB-flex S Al_20221114_EN.docx
10. Cut the slide profile straight at the end of the chassis
profile ( viewed in running direction) and clip it on
flush.
11. Gently deburr the butt ends.
12. Each slide rail piece must be fixed at the start (viewed
in the running direction).
13. Using the drill (drill bit ø 3.4 mm), drill a hole in the
slide rail and chassis.
Do not drill through slide rail. The underside of the
slide rail must not be drilled or protruding.
14. After drilling, deburr and remove all chips.
15. Carefully knock in M4 x 8 plastic screw.
16. Cut the screw head carefully and flush.
17. Rework possible supernatants with the file.
18. Before intermediate elements or subsequent
elements, mount the slide rail flush with the end of the
chassis profile (viewed in running direction)
19. At the end of the conveyor, mount the slide rail flush
with the drive station.
Advertisement
Table of Contents
