Euroflex MB-flex S aluminium Quick Installation Manual page 14

14 Assembly
Fig. 4: Assembly the slide profiles on the modular belt conveyor
Quick installation guide_Conveyor system MB-flex S Al_20221114_EN.docx
11. Each slide profile piece must be fixed at the
beginning (viewed in running direction).
12. Using the drill (drill bit ø 3.4 mm), drill a hole in the
slide profile and holding profile.
Secure the profile with a support against bending!
13. After drilling, deburr and remove all chips.
14. Carefully knock in M4 x 8 plastic screw.
15. Before intermediate elements or subsequent
elements, mount the slide profile flush with the end
of the holding profile (viewed in running direction)
16. At the end of the conveyor, mount the slide profile
flush with the drive.