Table of Contents
Advertisement
10
Assembly
WARNING
Risk of injury and serious damage to property due to improper installation!
A lack of knowledge about the system and experience in assessing and averting residual risks
during proper assembly can result in injury and even death.
»
Before working on the system, turn it off and guard it from being switched back on.
»
Prior to working in the system area, empty or clear the system.
»
Regularly remove product residues and splitters from the entire system area.
»
Check that the screw connections on all load-bearing and moving parts are tightened correctly
»
Check correct function of bearings and links.
»
Check the function of the safety devices.
»
Wear appropriate personal protective gear in the system area.
Prerequisite:
▪
System is switched off and safeguarded against being restarted.
3.2
Assembly the slide rails and slide profiles on the modular belt
conveyor
Observe the following during assembly:
▪
Install the slide rails and slide profiles in a number of continuous lengths where possible.
▪
In areas with high loads, the slide rails and slide profiles must be separated to enable
expansion. Separation is required at bending wheels, deflection units and drive units.
▪
Never connect slide rails and slide profiles in horizontal or vertical sliding bends.
▪
Avoid slide rail and slide profile connections at the connection points of the holding and
chassis profiles.
Fig. 2: Assembly the slide rails and slide profiles on the modular belt conveyor
Quick installation guide_Conveyor system MB-flex S Al_20221114_EN.docx
1
2
1. Clip the slide rails (2) onto the chassis profile.
2. Press the slide profiles onto the holding profile (1).
Advertisement
Table of Contents
