3.2
Assembly the slide rails and slide profiles on the modular belt
conveyor
Observe the following during assembly:
▪
Install the slide rails in a number of continuous lengths where possible.
▪
In areas with high loads, the slide rails must be separated to enable expansion. Separation is
required at bending wheels, deflection units and drive units.
▪
Never connect slide rails in horizontal or vertical sliding bends.
▪
Avoid slide rail connections at the connection points of the guide profiles.
1
Fig. 2: Assembly the slide rails and slide profiles on the modular belt conveyor
3.2.1
Assembly the slide rails on the modular belt conveyor
Quick installation guide_Conveyor system MB-flex O Al_20221114_EN.docx
1. Clip the slide rails (2) onto the chassis profile.
2
2. Press the slide profiles (1) onto the holding profile.
1. Clip the slide rails (2) onto the chassis profile.
2
2. Check the slide rail for damage.
ǃ
3. Chamfer the slide rail at the start (viewed in running
direction).
Only use undamaged slide rails.
Assembly
11