Table of Contents
Advertisement
3.2.2
Assembly the slide profiles on the modular belt conveyor
Quick installation guide_Conveyor system MB-flex S Al_20221114_EN.docx
1
1. Press the slide profiles onto the holding profile(1).
2. Check the slide profiles for damage.
Only use undamaged slide profiles.
3. Chamfer the slide profiles at the start (viewed in
running direction).
4. Press the slide profiles in the running direction onto
the top of the holding profile.
Avoid the development of "waves" in the slide
5. Mount the slide profile seams with a gap of
approx. 2 mm and offset.
6. Cut the slide profiles at an angle in the running
direction.
7. Gently deburr the butt ends.
8. Always mount the slide profiles over the seams of
the holding profile.
9. Cut the slide profile straight at the end of the holding
profile ( viewed in running direction) and press it on
flush.
10. Gently deburr the butt ends.
profiles by clipping it on completely.
Assembly
13
Advertisement
Table of Contents
